POR-15 High Temp extreme heat coating for metal - How to apply it and use it

Описание: Shop: https://por15.com/products/high-temp

POR-15 High Temp is a direct-to-metal (DTM) coating designed for use on metal subject to extreme elevated temperatures. The recommended application is two or three thin covering coats applied directly to properly prepared metal. Apply three thin coats for industrial and applications subject to corrosive material exposure. Dries to the touch but will remain relatively soft until exposed to heat over 300-400°F. Unaffected by moderate term weather or UV light exposure. For use on surfaces where heat resistance up to 1200°F (648°C) is needed. Excellent for exhaust manifolds, headers, diesel stacks, high heat machinery, barbecues, smokers, etc.

Liquid paint directions:

Surface must be clean, dry, and free of all old paint, oil, and other contaminants before painting. For top performance, sandblasting is recommended. If sand blasting is not available, wire brush and rough sand with course sandpaper 80-180 grit. Degrease and agitate surface with POR-15 Cleaner Degreaser and rinse. Etch surface with POR-15® Metal Prep and rinse. When surface is dry, apply one thin coat and allow it to dry. Recoat after 1 hour or up to 24 hours, depending on ambient temperature and humidity. Allow POR-15 High Temp Coating to dry for 24 hours before being heat cured at a temperature of 350°F for at least 15-30 minutes and then allowed to cool down. For spray applications thin with POR-15 Reducer Solvent or Xylene up to 10 percent.
CLEAN UP: Do not put left-over paint back into can. Clean all equipment immediately after use. At the same time, flush out all fluid lines and carefully clean pressure pots. Use new clean POR-15 Reducer Solvent or urethane cleaner only. It is also good practice to periodically clean the spray tip or the fluid tip/air cap combination during the course of the working day or shift.

Aerosol spray directions:

Surface must be clean, dry an free of all oil and other contaminants before painting. Sandblasting is the optimum surface preparation. Protect surrounding areas from spray mist. Must be heat cured at a minimum temperature of 400°F (205°C) for two hours. More than one coat may be required for full hide.

Shake can at least one minute before and occasionally during use.
Spray surface with steady, even strokes at a distance of 8 to 10 inches. Several light coats give a better finish than one heavy coat. For best results, recoat within 1 hour or after 24.

Cleanup: To prevent clogs in spray nozzle, hold can upside down and spray until clear gas appears. Completely empty cans may be recycled or disposed of with regular trash. Dispose of partially empty cans responsibly. DO NOT puncture, incinerate or compact.