Wolder 9" miTab CHICAGO Tablet Digitiser Replacement Repair Teardown

Описание: Wolder miTab CHICAGO / phoenix tablet touch screen digitizer glass touch panel Wolder 9" Tablet digitiser replacement. First remove any cards from the SD slot. Remove two screws then the back cover can be unclipped, a guitar pick is useful for this. Take care when removing the back cover as it has a small speaker stuck to it. Unplug the touch screen cable by lifting up the flip tab. I use a hot air gun set to about 80 degrees C to soften the glue holding the touch screen. Take your time with this and re heat as necessary. Also take care not to damage the LCD panel underneath. With the touch screen removed clean the LCD panel to remove any fragments of glass or finger prints. Isopropanol is my solvent of choice for this. Remove the protective film from the new screen along with the backing tape for the adhesive strips. Press the new touch screen in place reconnect the cable and test. Click Here to Subscribe http://bit.ly/1nformatica
Aliexpress link:
http://www.aliexpress.com/snapshot/69...

Tools used:
Heat gun:
http://bit.ly/HotAirGun

Infra Red Thermometer:

http://bit.ly/IR_Thermometer
Good source of electronic parts: http://bit.ly/ElecComps

DISCLAIMER: Unless otherwise stated all products shown in this video have been purchased personally. The description and video may contain links to products which might be affiliate links, so if you click on one of the product links I could receive a small commission. This does not affect the price you pay. If you do purchase through my affiliate link this will help fund future videos, thank you for your support! #1nformatica