French Cleat Drill Holder (DIY Tool Storage)

Описание: #frenchcleat #toolstorage #woodworking #brattonbuilt #powerdrill #workshophacks #DIY

Here's how to make a drill holder or a "quick release drill holster" for your french cleat wall. Looking for better tool storage? Are your tools hogging up valuable workbench real-estate? I just purchased some drills, and they needed a home. This holster is a simple design with the charger attached to the side. See below for all the tools and supplies used, a cut list, and step by step directions.

Support Bratton Built by Subscribing to our YouTube Channel

If you're new to French Cleats check out our French Cleat Wall Video:    • French Cleat Wall (DIY Tool Storage)  

CUTS USED FOR DRILL HOLDER
(3) 10″ x 10″ piece of 3/4″ plywood
(1) 10″ x 10 1/2″ piece of 1/2″ plywood
(1) 10 1/2″ piece of 1×3 (for cleat)

SUPPLIES USED TO MAKE DRILL HOLSTER
Wood Glue
(4) 1 1/4″ Screws (to attach back)
(4) 1 3/4″ Screws (to attach cleat)

TOOLS USED TO MAKE DRILL RACK
Table Saw
Power Drill
Drill Bits
Counter Sink Drill Bit
(2) 12″ Clamps
Jig Saw

STEP BY STEP DIRECTIONS ON MAKING DRILL HOLDER

STEP 1: CUT THREE 10″ BY 10″ PIECES OF 3/4″ PLYWOOD

STEP 2 (OPTIONAL STEP): CUT RABBETS 3/4″ BY 1/2″.
If you're not comfortable making rabbets or just want to make this build easier do a butt joint by attaching the top piece to the top of the two side pieces.

STEP 3 (ANOTHER OPTIONAL STEP): CUT TRIANGLE PIECE OFF OF SIDES
Just for looks really. Although it does make it slightly easier to access the drills.

STEP 4: MEASURE FOR DRILL SLOTS
My slots were 5.5″ deep and 2″ wide

STEP 5: CUT OUT SLOTS FOR DRILLS
I drilled a hole to help with using the jig saw, but this cut is doable with just the jig saw.

STEP 5: ATTACH BACK
Cut 10.5″ by 10″ piece of 1/2″ plywood and attach it to back. I used wood glue and then fastened with four 1 1/4″ wood screws after pre-drilling and counter sinking holes.

STEP 6: ATTACH FRENCH CLEAT
Use 10″ long piece for cleat. My cleat wall is made with 3/4″ lumber. Don't forget to pre-drill and counter sink. I used wood glue and 1 3/4″ screws here so they would drill through to the side pieces for extra support.

STEP 7: ATTACH BATTERY CHARGER

If your charger is like mine you can mount it to the side of your holder.

Badda Bing!

Like, Share, and Subscribe!