4) Sgrossatura della tavola parte quarta Sgrossatura finale a pialletto

Описание: Ultima parte della sgrossatura della tavoladi violino, utilizzando i pialletti di ottone a lama curva

ENGLISH TRANSLATION of the written notes in the video, in order of appearance :

00:08 - Roughing of the top plate _ Part four - Final roughing with fingerplane

00:18 - Continue the roughing with fingerplanes, removing all the marks left by the gouge

00:29 - Use two fingerplanes with blade and sole slightly curved, one midsize (38mm lenght, 12mm blade width) for the areas of wider curvature, another smaller (31mm lenght, 10mm blade width) in order to reach the concave zones near the edge of the C

00:56 - Start with the midsize fingerplane, approaching the center line but always respecting the flat strip in correspondence of the sixth

02:05 - Be careful not to change too much the thickness on the outside perimeter of the edges, that should remain of about 4.5 mm

03:12 - Switch to the smaller fingerplane to be able to work the concave area near the edge of the C, otherwise not accessible with the larger one

03:30 - Do not touch the edge platform, that should keep the thickness of about 4.5 mm set during the working with gouge

04:18 - Alternate the use of the two fingerplanes according to need, until you get the desired shape of the arching

05:06 - Always use the oblique light to better see the shapes and surface relief

06:21 - Check that the thickness of the edge has remained at about 4.5 mm on the perimeter, increasing to about 5.5 mm at the end of the corners

Index of videos :

www.davidesora.altervista.org


#costruzioneviolino #violinmaking