etrailer | Review of SeeLeveL Smart RV - Holding Tank Monitoring System - SE49VR

Описание: Click for more info and reviews of this SeeLeveL Smart RV:
https://www.etrailer.com/Smart-RV/See...
Check out some similar Smart RV options:
https://www.etrailer.com/dept-pg-Smar...

https://www.etrailer.com
Don’t forget to subscribe!
   / etrailertv  

Full transcript: https://www.etrailer.com/tv-Demo-SeeL...
Hello everybody, this is Jeff at etrailer.com. Today we can take a look at the C-level RV holding tank monitoring system with the water pump switch and this is for fresh and black water tanks. Now if your RV tank monitor readings will change from 25% to empty in the blink of an eye, that could be a problem. So this monitoring system here will let you track and display the levels of your RV's holding tanks at just the push of a button. It is designed to hardwire to your C-level sensors and it does include these two 12 inch sensors. One is for freshwater tank, the other's for your black water tank.

Now what's nice is your traditional tank monitors always have a reputation for being unreliable. There's only a few sensors that are installed inside the tanks, meaning that they usually only measure in quarter increments and can send false readings if they get dirty. And when you're keeping an eye on how much fresh water you have, the difference between 25% full and empty means a lot, and that inaccuracy could be a problem. So it's nice with these sensors, they are designed to mount to the outside of your holding tanks, rather than using interior probes. As we mentioned, includes the two sensors.

These will prevent false readings that could be caused by accumulating debris, and they'll provide readings with single digit accuracy. Also, what's nice about these, they can be trimmed or stacked with additional sensors to match your tank size. And you can see where they can be trimmed here, each where there's line is, there's about one and a half inches between each one there. And that's where you could trim it to make it fit. One sensor could accommodate five inch up to 13 inch tall tanks.

And if you stack additional sensors with it, it can accommodate tanks up to 25 inches tall. Now the display monitor right here, this will also show your battery voltage. You could push the battery to show the voltage. It does offer a diagnostic mode that'll check status and signal strength of your sensors, and it'll even give you air codes to alert you of any issues. You just need to check the manual for the suggested solutions.

We did mention this one right here. You can see it has this integrated switch, which will activate the water pump. The three-way function will let you connect to switches in your bathroom, kitchen or elsewhere. And what's nice is you can use multiple monitors so that you can check tank status from your service bay or inside your RV. And these are a very easy installation. All you have to do is cut a hole for the recess mount of this monitor and on the sensors, all you do is remove the backing tape right here and then just attach the sensor onto the tank and then hardwire it together. As you can see, includes the long pigtails for installation. The tabs up on top of the sensor, they can be trimmed, indicate which tank it's on, and the length of the whole sensor, as we mentioned, can be trimmed every one and a half inches to match the height of your tank. Right up the top here, it has all the bus wiring that'll let all the sensors splice together to one line. And what's nice is you can use your existing wiring from your old tank monitor system to install this. Application, again is for two tank systems for RVs and motor homes. The overall length of this monitors four inches wide, two and three quarter inches tall, and about one and a quarter inch deep. And one last note on this is your SeeLevel tank monitoring systems are not compatible with metal tanks. But that is gonna do it for a look at the SeeLevel RV holding tank monitoring system with the water pump switch or your fresh and black water tanks.