Installing Alu X-End Install on Replicator 2/2X Upgrade
Автор: MrScottJD
Загружено: 2014-06-02
Просмотров: 3992
Описание:
This is an install video for Carl Raffle Aluminum X-Ends on a Makerbot Replicator 2/2X with linear ball bearings.
The X-End installed was for Revision 1, with Revision 2 stepper mount and pulley idler bracket. This is the current version as of June 2014.
The instructions should be the same for other revisions but may have one or two small differences. It's recommended you read over your instructions provided to make sure your not missing anything.
For the Alu Carriage install video for removing the stock carriage you can watch my other video. This is only needed if you are installing the Alu Carriage and the X-Ends:
• Installing Alu-Carriage for Replicator 2/2...
You can purchase the X-Ends and Carriage @:
http://shop.raffle.ch/
Also read users comments about this upgrade @:
https://groups.google.com/forum/#!top...
Повторяем попытку...
Доступные форматы для скачивания:
Скачать видео
-
Информация по загрузке:
