How to make a Solenoid with commercial quality from scratch! Mini size!
Автор: Research and Build
Загружено: 2017-04-22
Просмотров: 205123
Описание:
Build this mini-sized Solenoid from scratch using a nail, wire, a wood dowel, and some sheet metal.
Many people that build solenoids make the mistake of leaving them "open", without a metal frame. This makes them weak! You have to focus the magnetic energy into the center of the coil as much as possible.
Along with putting a metal frame around the solenoid, you also want a metal "stop" inside the non-working side of the solenoid, this will act like an additional magnet, further increasing the pull force on the plunger.
This coils specs:
34AWG magnet wire recovered from a small electric motor
@490ish turns
6V powered in this demonstration
9.5 ohms
using a small metal nail with sharp end cut off as plunger
Force of pull with full metal frame: About .150lbs at max plunger depth.
Duty cycle must be kept pretty low since this solenoid is only 9.5ohms, thus draws quite a bit of current at 6V - 34AWG wire gets hot at that current draw. As the coil gets hot, the solenoid will get weaker
Повторяем попытку...
Доступные форматы для скачивания:
Скачать видео
-
Информация по загрузке:
