Extra Tall Cat Gate by Rover Company

Описание: Rover Company pet gates come in different heights that allow you to easily create any number of lengths and configurations. Simply connect the gates together, and position as desired. These modular pet gates are made of durable white PVC panels, making setup a breeze. You can connect as many gates as you'd like to create a variety of lengths and heights.

Decide which mounting option will best fit your needs. See bullets below for mounting options.
• Face mounted gates require the hinging and latching sides of the gate to be mounted to the trim-side of a doorway/hallway, and less than 42” wide.
Example: mounted at the end of a hallway where the ends of the walls are accessible.
• ‘V’ Shape mounted gates require the hinging and latching sides to be opposing to one another, and less than 42” wide. Most mounting positions can accommodate ‘V’ Shaped mounting.
Example: mounted in the middle of a hallway with no doorways on either side.
• If you are mounting the gate with additional Stacking Panels in a face mounted configuration, the overlapping upright bars need to be in-line with one another for proper setup. (See Figure 1) Read both sets of instructions completely before beginning the installation.
• If your mounting location requires you to have a gate width wider than 42”, an extension panel will need to be purchased from www.roverpet.com.
For maximum strength capabilities, mount the Rover Pet Gate on the same side of doorway/hallway that your pet will be contained. Allow a ‘V’ Shaped arrangement to extend into the area that your pet will be contained.
If your needs require the gate to be left-hand opening, un-snap the #RGH Handle from the Rover Panel, and install it on the opposite side of the Panel. Note that for left-hand opening gates, the assembly procedure will be reversed for the #RGC Clasp set installation that follows. (See diagram on next page)
The #450 Wall Clasps (2-1/4” length) need to be secured to the wall on the HINGED SIDE of the gate. They need to be aligned vertically along the doorway/hallway opening. The #450 Clasps should be mounted 6” above the bottom of the gate, and 6” below the top of the gate. Use the supplied hardware to mount the clasps to the wall using a #2 Phillips screwdriver. Use a 1/8” drill bit if pilot holes are needed. Don’t Over Tighten Supplies Screws.
• If your Rover Pet Gate was supplied with more than (2) #450 Clasps, the remaining #450 Clasps need to be mounted between the top and bottom #450 Clasps that were just installed on the wall, verify the locations will not interfere with the center bar of the Rover Panel.
Mount the #350 Wall Clasps (1-1/8” length) in the same manner as in Step 4. Mount them on the opposite wall from the installed #450 Clasps. The #350 Clasps are used on the LATCH SIDE only with the #RGH Handle.
Remove the installed #250 Clips from the Rover Panels. Expand the panels to stretch between the mounted #450 and #350 Clasps. Reinstall the #250 Clips to the top and bottom of the Rover Panels. Snap the Rover Pet Gate into the Wall Clasps. Make certain the HINGED SIDE of your gate is secured in the #450 Clasps.
Congratulations, you are now ready to use your Rover Pet Gate!


Want To Learn More?

Links:


USA Made Tall Pet Gates : http://www.roverpet.com/dogs_cats/rov...
Company Website : http://www.roverpet.com
Dog Gate Selection : http://www.roverpet.com/pet_gates.php
Extra Tall Cat Gate: http://www.roverpet.com/dogs_cats/cat...
Facebook:   / roverco  
Twitter: http://twitter.com/#!/roverpet1