Making a boring bar holder

Описание: One if the tools I need for my Monarch Merit lathe is a holder for using boring bars. In this video I make a holder to fit a 1-1/2" diameter boring bar from a piece of 4140 steel. I put the retainer screws located 45 degrees from the top in order to allow for set screws from the top side of the boring bar when using adapter bushings.












Disclaimer This video and any other associated videos created by this author are for entertainment purposes only. They are not intended for instruction or demonstration of the proper ways to perform the tasks shown. The author and creator of this and associated videos is not responsible for any actions taken from the viewing of these videos. If an individual decides to duplicate what is shown in this or any other video by the same author, this person is responsible to understand the proper operation of the equipment involved, the hazards associated with the tasks performed, to understand safety procedures and personal protective equipment (PPE) requirements, and to adhere to all applicable regulations and laws. The author of this video may be seen wearing a ring on their hand, this is a rubber safety ring. Jewelry should never be worn while operating equipment or machinery. Unless specifically stated, this video is not sponsored by or to be considered an endorsement of any brand, business, channel, or person which may be mentioned. Unless otherwise specified, any music in this video is from the YouTube audio library and is used in accordance with the YouTube Audio Library License.