NO SOUND ONKYO TX-NR515 switched to FUNCTIONAL ANALOG MODE(bad DSP,no reflow/reball,HDMI BD: Ignore)
Автор: Michal Sedláček
Загружено: 2020-02-13
Просмотров: 43927
Описание:
THE DESCRIPTION IS IN THE SUBTITLES - TURN THEM ON.
Audio signal processing in Onkyo receiver TX-NR515 with damaged DTS chip is possible switch from pure DIGITAL mode (processing in damaged DSP) to PURE ANALOG MODE (without DSP). If you have receiver after BGA rework / reflow / reballing and the DSP chip fault still repeats, you have "pure analog way". In fact you have "stereo mode with pure analog input".
You can mix all ANALOG imputs, but only to LF and RF power outputs. All other amplifiers and theier speakers power outputs are ready, but power amps are without low-power audio input signal. If some ELECTRONIC SPECIALIST modify main amplifier board, you can conver this receiver to 7ch 130W/6ohm analog amplifier with functional remote.
HDMI BD: Use = digital processing of all channels throught damaged DSP processor
HDM BD: Ignore = from analog imnputs is L + R channel switch direct to LR + LF power amplifier, other speakers are connected to power amp but amps havent low-leve signal
Повторяем попытку...
Доступные форматы для скачивания:
Скачать видео
-
Информация по загрузке:
