Blomberg rapidjet shirts 60 fast+ and steam

Описание: Well what can I seriously say 🫠

Beko have literally went and ruined one of the best cycles on their WT range of machines

I don’t get why it uses half a tub of water on the main wash I get it’s meant to make the wash more gentle but personally prefer the low level WTG does for shirts

Also WTF WAS THAT PATHETIC EXCUSE OF A FINAL SPIN 🫣 cancel entire spin after 3 balance attempts FTW 🙌

And finally don’t get me started on the awful steam phase guess it’s a good thing that the machine skipped the final spin as it wasn’t necessary with the fact the machine soaks the clothes then heats them up to 50°C on “steam” 🤓

In the end was left with hot soaking wet clothes thanks to beko’s very smart logic don’t know how my dryer managed to dry them in an hour as didn’t re spin them

0:00 Prepare the load
2:37 Main wash (saturation soak)
7:59 Main wash (soak phase with heat to around 40°C)
22:41 Main wash (water level increased to half way up the door begin heating to 60°C with normal action)
52: Main wash (heating ended)
54:38 Drain
56:08 First rinse with aquatech
1:04:10 Drain
1:05:40 Final rinse with aquatech
1:13:36 Drain
1:15:17 Final spin first burst 300rpm
1:24:33 Final spin second burst 600rpm
1:29:37 Entire final spin skipped due to 3 unbalanced attempts advance onto “steam” phase
1:52:36 Drain and additional short 600rpm spin to remove excess water from clothes after boil phase
1:57:23 anti crease+, End and results


Glitching was fine right up until the steam Phase where it required inverter resets (at 1:34:30) could potentially be another reset somewhere as haven’t checked thoroughly