Red Special Build - PT05 Repairs - Router Bearing Marks

Описание: Part 01 - Blockboard Sandwich -    • Red Special build - PT01 - Blockboard sand...  
Part 02 - CNC Body -    • Red Special build - PT02 - CNC Body Cuts  
Part 03 - CNC Neck -    • Red Special build - PT03 - CNC Neck  
Part 04 - Body Glue Up -    • Red Special Build - PT04 - Body Glue Up  
Part 05 - Router Bearing Repair -    • Red Special Build - PT05 Repairs - Router ...  
Part 06 - Applying Veneers -    • Red Special Build - PT06 - Applying Veneers  
Part 07 - Binding and Staining -    • Red Special Build - PT07 - Binding and Stain  
Part 08 - Veneer Sand Through Repair -    • Red Special Build - PT08 Repair - Veneer S...  
Part 09 - Neck and Fingerboard -    • Red Special Build - PT09 Neck and fingerboard  
Part 10 - Neck finishing -    • Red Special Build - PT10 Neck Finishing  
Part 11 - Frets -    • Red Special Build - PT11 Frets  
Part 12 - Assembly -    • Red Special Build - PT12 Assembly  
Part 13 - Demo -    • Red Special Build - PT13 Demo  

: : : Repairing Router Bearing Marks : : :

This video is a short look at one approach to remove indents caused by the router bearing in the mahogany side veneers on a Red Special replica body during the making of the binding channels.

The video shows, in almost real time, the method of using steam from a clothing iron to re-expand the crushed wood fibers in the veneer. I used a paper towel folded over a few times, dipped into a glass of water and lightly wrung out. I applied only a small amount of pressure, as you might when ironing clothes, since it was the steam doing the job. The iron was set to it's highest/hottest setting. Some areas, around the horns, for example, took more time and care than the flatter areas, as illustrated in the video, but the results are much the same. This might save you from sanding through the precious amount of veneer on those sides when trying to level it back out.

(Muffled) Music: "Nothingman" by Smokescreen. (My old band)