OPTICALLY ISOLATED GATE DRIVER AND MOSFET BASED DC SOLID STATE RELAY WITH CURRENT & FUALT OUTPUT
Автор: TWO VOLT
Загружено: 2017-01-27
Просмотров: 214
Описание:
DC solid state Relay build using optically isolated Mosfet gate driver & high current Mosfet, this relay also provides current feedback as voltage output and fault TTL voltage output as current goes above set point. Current feedback designed around op-amp as signal conditioning which measure the current across low ohm shunt resistor. On board preset (trimmer pot) to adjust the fault current set point. Normally current fault output is high TTL it goes low if fault condition occurs. Circuit available at www.twovolt.com
• DC Supply 90V DC Maximum
• Maximum Current Load 15Amps
• Gate Driver Supply 15V DC
Повторяем попытку...
Доступные форматы для скачивания:
Скачать видео
-
Информация по загрузке:
