Maghold build platform for the Makergear M2 3D Printer

Описание: http://hilo90mhz.com/maghold-build-pl...

I used recessed 16mm long M3 screws to mount it which is just the right length with the rubber spacers.

I mounted the temp sensor by using replacing one of your magnet hold down screws with an M3 bevel head 12mm long screw which made it long enough that I was able to bolt the temp sensor to it with an M3 locknut from the back.

The stuck on heater took allot of force to remove from the old build plate but was not impossible to remove with just some pulling force from my hands. And seems to have been removed undamaged! everything works once restuck onto the new platform. I put some kapton tape around the edges just for good measure but it probably would have been fine without this.