3D Probe 02 Mapping a toolpath to a irregular surface

Описание: In this video I show you how to install the software, how to measure the offset betwae the endmill and the probe, and how to map the toopath on an irregular surface.
I was tricky to make this video, so if you see the continuity dont match exactly its because it was made from a lot of recordings.
The link to the files for this are this ones:

http://stepcraft.mx/autoleveler_v1.00...
http://stepcraft.mx/macros_for_3Dprob...

The autoleveler plugin is made by Cahit Ates from the cnczone forum, and the macros are made by me.
Please review the video carefully, I try to be as clear as possible and I make some warnings about usign the probe, be mindfull and carefull with that because if you use the probe outside the macros or the probe its not connected and working correctly you may break it. I made some modifications to the macros yesterday and now all the macros gives you a message before they execute the command so you know what the macro is going to do.
Try to test this macros with some soft material before you use them with a hard material so you can be sure on the operation of them. I dont take any responsability for any damage this may cause to your machine or probe.
On the next video Im going to show you all the macros, how they work and what you can do with them.