Microfluidics Lecture (Sensors and Devices 05_1)

Описание: In this lecture I explain few methodologies for the fabrication of microfluidic devices. From glass to glass/PDMS to 3D printed microfluidics and single PDMS block. Which one is the best?

researches mentioned in the lecture:
how to make PDMS/Glass microfluidic devices:    • Fabrication of PDMS Microfluidic Devices  

Lung on a chip:    • Lung on a Chip -- Wyss Institute  
Multi organ on a chip:    • Lung on a Chip -- Wyss Institute  

Soft wearable microfluidic device for colorimetric sensing of sweat: https://stm.sciencemag.org/content/8/...

Soft robotics:
   • Rubbery robot fingers play piano faster th...  
   • The incredible potential of flexible, soft...  
   • Soft robot run over by a car  

The Octobot:    • Introducing the Octobot  

3D printed microfluidic devices:
https://pubs.rsc.org/en/content/artic...
https://pubs.rsc.org/en/content/artic...
https://iopscience.iop.org/article/10...
https://iopscience.iop.org/article/10...

ESCARGOT:
   • Simple fabrication of complex microfluidic...  
https://onlinelibrary.wiley.com/doi/f...

"thanks" to the 2020 pandemic, part of the course BioNanoTechnology: Sensors & Devices taught at Wageningen University (the Netherlands) was done online.
Please note that these videos are not the whole course, and many things are only mentioned here and discussed further during live lectures.

00:00 Introduction
02:07 Glass Microfluidics
05:24 PDMS-Glass Replica Molding
11:00 PDMS-PDMS Microfluidics
15:26 3D Printed Microfluidics
20:14 Embedded Scaffold Removing Open Technology (ESCARGOT)