JM GSVM & GSTM V Grooving Machines — Installation & Commissioning Guide (Vertical & Reciprocating)

Описание: Professional installation & commissioning for JM GSVM (vertical V grooving) and GSTM (reciprocating V grooving) machines — a single video covering safe lift-in, precision leveling, mechanical mating, electrical & hydraulic hookups, and first-run validation for both machine types.

Highlights covered:
• pre-installation checks: packing list, accessories and lifting gear verification
• safe crane lift-in and placement on a level, load-rated foundation; fit independent control consoles per layout
• base shimming and three-point leveling procedure (front-center + side midpoints) using spirit or electronic levels; apply preload and torque foot nuts in sequence
• mechanical alignment: mating feeder units, dowel-pin alignment, progressive bolt tightening and final seating checks
• routing and securing drag chains, hydraulic and oil hoses; install guide rods, support brackets and protective covers
• wiring: motor drive, encoder & network cable routing with cable clamps; confirm three-phase 380 V supply before integrator power-up; chiller single-phase 220 V hookup for laser or cooling systems where applicable
• commissioning checks: control PC boot, manual mode pump run, verify hydraulic pressure rise, test axis motion and trial grooving cycles; troubleshoot phase sequence by swapping two phase wires if indicator lamps or pumps do not respond
• safety reminders: always de-energize before wiring, follow local crane and electrical codes, and consider JM on-site commissioning for guaranteed uptime

Why this matters: correct commissioning preserves groove geometry, reduces start-up issues and delivers repeatable production quality for both vertical and reciprocating V grooving applications.

Request on-site commissioning or operator training: www.jianmeng.com
Contact: [email protected]

#jm gsvm, gstm, vertical v grooving, reciprocating v grooving, installation, commissioning, machineinstallation, vgrooving, electricalhookup, hydraulic, cnc, manufacturing, safety