Another RECALLED Nissan Rogue VC-Turbo 3 Cylinder Engine, But Was This One The Drivers Fault?

Описание: For parts visit www.Importapart.com or email us at [email protected]

For other I Do Cars content check out my wife's channel at    / @thecarwifelife  

Every week I post a new teardown video of a blown up or suspected bad engine. Check out a few of my favorites!
Jeep Wrangler Hurricane 2.0L Turbo Teardown    • DEAD AT 63K MILES! Jeep 2.0L Turbo Hurrica...  
Ford 2.3L Ecoboost NEGLECT Engine Teardown    • SHOP FAILED! 2019 Ford Ranger 2.3L Ecoboos...  
The BEST small Diesel Engine, 1.9L VW TDI Teardown    • "BAD" Volkwagen Jetta 1.9L ALH/AHU TDI Die...  

Today we teardown the 2nd Nissan Rogue 1.5L KR15DDT 3 cylinder VC-Turbo engine I've run across. This engine, with only 71K miles, was replaced with a good used engine, but why? Was it what usually plagues these engines or something else, perhaps an outside failure? That's the point of this video! To find out what happened, why it happened, and what parts survived the failure.

Why am I doing this? My name is Eric and I own and run Importapart, a full service auto dismantling business. Part of our model includes buying blown up and bad engines to dismantle for parts. We salvage the good, sellable parts and recycle rest. No, we don't rebuild engines but we do sell parts to people who do!

As always I hope you enjoyed this video. I love all of the comments, feedback and even the criticism. Catch you on the next one!

-Eric


00:00 Intro
03:10 Pulling the plugs. WET
03:49 Removing the turbo and inspecting
05:32 Unbolting the valve cover and remov OH MY NO! That's not good!
08:28 Zipping all of the timing cover bolts and prying it off
11:56 Removing the High pressure fuel pump
13:20 Cramming the cam cramps loose, and removing the cams
16:04 Inspecting the entire valve train, its FROTHY
17:50 Cracking the head bolts loose and pulling the head off the block
18:32 THERE'S YER PROBLEM LADY Eric O Reference
20:18 SCIENCE. NO DISCONNECTING LINKS?
20:57 Unbolting the Plastic oil pan that leaves 1/2 quarter in it when you remove the drain bolt
22:25 Removing the capture for the pin for the A Link
24:58 Finally removing the VC actuator
25:45 removing tha dismantling the oil pump for inspection
27:43 unbolting the upper oil pan to reveal the VC System
29:07 How the Variable Compression system works
31:32. Dismantling the VC System starting with the C link
32:55 Lifting the control shaft out of the engine
34:04 Unbolting the L Link and getting the pistons stuck past the rings, OOPS
39:22 cracking the final bolts loose and removing the crankshaft
39:53 Complete VC System and rotating assembly inspection, including bearings, rings, pistons, Links, control shaft, crankshaft and block
43:59 Summary