$35 Kmart Anko Single Monitor Arm 🤔
Автор: Matthew Lewington
Загружено: 2024-05-06
Просмотров: 11145
Описание:
Why wont my arm move?
There are small holes on each joint of the arm with a small grub screw in them. Just put an allen key in the hole and loosen the grub screw. This will allow you to move it around then tighten them backup when your done :) View 5:41 for screw locations
A look at the Anko single monitor arm. In summary If using as your primary monitor arm for your desk maybe spend a bit more for a JB XCD arm. But might be "OK" for something not used often or for lightweight monitors.
ANKO ARM: https://www.kmart.com.au/product/sing...
XCD ARM: https://www.jbhifi.com.au/products/xc...
The Anko arm also missing a 3mm Allen key to adjust swivel. You will need to source one.
During the install the back cover did snap and alot of the screws felt a bit dodgy. Updates On the status of how hard my monitor got owned by gravity will be updated below:
6/5/24 Installed
7/5/24 Yeah still standing for now....
3/6/24 Its still up, though iv noticed the monitor is slowly lowering it self.
3/9/24 Still holding though its drooped down a bit.
Повторяем попытку...
Доступные форматы для скачивания:
Скачать видео
-
Информация по загрузке:
