Different Types Of Soldering Joints

Описание: A few episodes back we covered types and functions of soldering irons and today we're doing a demonstration using the butane setup that may interest you if you're doing some wiring.

But first, we need to touch on the cutters. Cutters have different diameter holes for different gauges of wire. If you use too small of a hole, you're going to gouge into the wire and cut some of the strands.

The first joint example is called a pigtail. It's pretty simple being that you take two of the wires to cross them and twist them together before soldering them. Take your hot iron and touch it to the bottom of the wire, let it get up to temperature, and toucht the solder to it to melt it into place. What you don't want to do is touch the solder to the iron and burn it in that way because that will create a cold joint and create a failure.

The next option involves meshing the two wires together. You'll want to push them together, twist them around and then continue to solder.

The third option is similar except you don't have to mesh the wires together but you do have to cut the insulation back a bit farther. Put the wires together about midway, twist one side, and then use a micro-torch to solder them together.

Websites:

https://www.PowerNationTV.com
https://www.PowerBlockTV.com

Facebook Pages:

PowerNation -   / powernationtv  
PowerBlock -   / powerblocktv  
PowerNation Daily -   / powernationdaily  
Detroit Muscle -   / detroitmuscletv  
Engine Power -   / enginepowertv  
Truck Tech -   / trucktechtv  
Xtreme Off Road -   / xtremeoffroadtv  

Twitter:

PowerNation -   / powernationtv  
PowerBlock -   / powerblocktv  

Instagram:

PowerNation - @PowerNationTV
PowerBlock - @PowerBlockTV

For more on PowerNation, check out PN+ at http://bit.ly/2oTCIyJ