WaterBox Peninsula Mini Auto Top Off Setup

Описание: In this video, I add a well-needed auto top-off system to the Waterbox Peninsula Mini 15g. Without a lid on top of the Peninsula mini, it loses a lot of water and needs to constantly get refilled with fresh RO water. Adding this Auto Top of System to the Waterbox is really going to help stabilize the water salinity, PH, and temperature. This was a really fun build with some minor issues along the way, so please be sure to watch till the end and leave a comment if you found this interesting.

The Auto Top Off unit that I installed by Digital uses dual-stacked magnetic float switches to turn on and off the ATO return pump. The bottom float is the primary switch and the top float is only to stop the pump in case of the bottom switch fails or gets stuck. Only time will tell if this float switch is going to be reliable but I am pretty confident that it will not cause flooding.

If you would like access to the STL files for this pump leave a comment or send me a message at iSeaLive.com.

Esty Store Link:
https://www.etsy.com/shop/iSeaLive

Link to the Digiten Float Switch (Not an affiliate or endorsement to buy this ATO unit)
https://www.digiten.shop/products/dig...
https://www.amazon.com/DIGITEN-System...

If you're interested in any of the aquarium-related models please leave a comment and check out https://www.Isealive.com

If you would like me to create something specifically for your nano reef aquarium, please leave a comment.

What Should I Make Next?

Thanks,

Mark

Video Content -

00:00 - Intro
00:36 - Opening the ATO Box
04:12 - Design Start
06:11 - 1st 3d Print
07:34 - Design Continued
08:02 - 2nd 3d Print
08:34 - Monster Jam
10:18 - Print 2 Complete
11:49 - ATO Reservoir
17:08 - ATO Water Return
19:25 - ATO System Installation
20:24 - Installation Complete
22:17 - Where to Get One?
22:37 - Signoff