Installation instruction Low profile mobile scissor car lift from mt automate MT-ML3000 CE

Описание: 1.Mobile control box
2.Power unit with 24V out put voltage
3.Power switch and AC contactor
4.Timer Delay relay
5.transformer
6.Anti-accident opening door
7.Loosen all the screws and remove the door
8.limit switch
9.three way air connection
10.power switch
11.air cmpressor joint
12.connect and screw up the oil pipe from platform to control unit
put the wire of limit switch out of from the control box.
13.the limit switch command to control the lifting height within safety working condition.
14.connect the air pipe to three way joint
15.Hit the air compressor to 6 pressures and connect the 16.pneumatic quick-connect connectors on both ends of the male and female
17.The external air source of the air compressor is to control the cylinder to open and thus unlock the movement.
18.Tubing trachea limit switch connected
19.Connect the power supply to the air switch to ensure that the household line is larger than 20 amps and 6 square meters
20.fill in No. 46 clean anti-wear hydraulic oil 6 liters
21.finished to install after installation
22.Keep pressing the up button until the platform rises to the right height
23.Thickened upper board can extend to support longer vehicles.
24.Keep pressing the down button
25.The platform will rise for 3 seconds to open the security lock.
26.Then fall again until it is completely
27.Press the up button to rise the height about of 10 cm
28.Put the Moving wheels into the groove
29.Because of decreased inertial ,platform will automatically leave the ground
30.Use the hook to conviently move the lifting platform